Must do every week
1. Check the wear of the linear guide, clean up the ash and soil caused by long-term operation on the guide slide block, and add lubricating oil appropriately.
2. Check the lubrication of ball screw. If less lubricating oil is found, pay attention to adding lubricating oil.
3. Check whether there is damage to the shield cable, and arrange replacement in time if damage is found.
4, check the module body and bearing, whether there is abnormal sound or vibration, vibration can be found in time to ask professionals to judge the fault.
5, check the motor, coupling and other obvious loose and noise.
6. Check whether the setting bolts of each sensor are locked or loose.
Monthly must-do
1. The belt module checks whether the tightness of the synchronous belt is appropriate
3. Readjust the running speed of each action
4. Check whether the sensor is normal
5. Whether the mechanical sliding table is interlocked with the machine is normal
6. Check whether the bolts of all moving parts are locked or loose
7. Determine whether the pipeline is broken or whether the wire connection is loose and loose